In some cases you may require to use an angled bracket (pictures below) as an additional mount for the sensor due to unnatural shape of the container, namely the lid, where the sensor should be installed.
It can be seen below, how, in some cases, the sensor is being attached to the angled bracket and afterwards installed in the container.
The bending degree of the bracket depends on the surface you are installing it. It is necessary to remember, that the lens on the sensor has to always point downwards in the center of the bottom and there should be no potential obstacles in terms of shape of the container and waste.
Process of attaching the sensor to the bent bracket | Drawing of the bent bracket |
|
|
If you require an actual drawing (model) of the bracket, please send us an email to support@nordsense.com. |